Information on Tools
Visit the manufactures web site for further possible usage of their tools.
 |
- Socket: 3/8" Drive ~ 12mm 12point -
- Universal Impact Socket for Ford Driveshafts
- Ideal for Solid Rear Axle (SRA) Vehicles
- Will work on Independent Rear Suspension (IRS) Vehicles)
Manufacture: Sunex Tools
Purchased From: http://www.sjdiscounttools.com/sun312zum.html Note: For the IRS, this socket will only loosen the driveshaft bolts half way due to the lack of pinion angle. |
 |
- Socket: 3/8" Drive ~ 15mm 6point -
- Ideal for Passenger Side Mid Pipe Bolt Remove and Install with Stock K-Members
Manufacture: Stanley
Part# J5215MH
Specs: 17.3mm Reach
Note: Not all sockets are created equal!
* Standard Size Reach = 12.5mm
* Mid Size Reach = 14.5mm
* Deep Size Reach = 48.5mm |
 |
- Front Wheel Drive Hub Puller -
- Removing the Half Shaft Outboard Stub from the Hub
Manufacture: OEM
Part# 27037
Rented From: http://www.autozone.com/home.htm Note: Tool has a 5/8" x 18 threads. |
 |
- Puller ~ 2 Jaw -
- Detaching the Tie-Rod from the Knuckel for IRS Equiped Vehicles
Manufacture: OEM
Part# 25914
Rented From: http://www.autozone.com/home.htm |
 |
- Pilot Bearing Puller Attachment -
- Will work on Ford Mustang Pilot Bearings
- Must Rent or Buy a Slide Hammer
Manufacture: OEM
Part# 27059
Specs: Fully Closed = .666" and Fully Open = 1.615"
Rented From: http://www.autozone.com/home.htm Note: The Pilot Bearing Puller Attachment requires a Slide Hammer from OEM Tools Part# 27033 or any other manufacture with 5/8" x 18 threads. Transmission Input Shaft that were used had a diameter of .668". |
 |
- Slide Hammer -
- Will work with the Pilot Bearing Puller Attachment Part# 27059
Manufacture: OEM
Part# 27033
Rented From: http://www.autozone.com/home.htm |
 |
- Heavy Duty Pry Bar -
- Sizes Offered in 8", 12", 18" and 24"
- Removal of Half Shaft Inboard Stub from the Pumpkin
- Disconnecting the Driveshaft Flange from the Pinion Flange
Manufacture: Pittsburg
URL: N/A
Purchased From: http://www.harborfreight.com/ |